Energy Guide

Page 94 of 104 Report No.: HK2107050725-SR
UL 507
Clause Requirement + Test Result - Remark Verdict
TRF No. UL507A
80.2.4 The catalog number or equivalent designation
mentioned in 80.1.1, marked on the motor-blade
and on the housing, provides adequate marking for
compliance with the requirement in 80.2.3. The
catalog number or equivalent designation marked
on the individual components is considered to
comply with the requirement in 80.4.1.
P
80.2.5 When the motor of an appliance complies with the
Exception to 23.1, the appliance shall be marked,
"Suitable for Industrial Use Only."
P
80.2.6 A unit requiring field-provided motor overload
protection as required by 26.4 shall have markings
readily visible during and after installation stating
such, and indicating the motor overload protective
devices shall be rated or selected in compliance
with the applicable installation code as specified by
the authority having juris diction
P
80.3 Controllers N/A
80.3.1 A separate controller for an appliance, other than a
general-use snap switch that is provided in
accordance with the requirement in 27.10, shall be
marked with:
N/A
a)The manufacturer's name; and
b)The catalog number or equivalent designation of
the controller unless the marking specifically
indicates, by means of the manufacturer's name
and by means of a catalog designation or the
equivalent, the appliance or appliances with which
it is intended to be used.
N/A
80.4 Shipping N/A
80.4.1 If an appliance is not completely assembled when
shipped from the factory, and is shipped from the
factory in more than one carton, and if
misassembly of components results in a risk of fire,
electric shock, or injury to persons (see 11.6 and
11.7):
N/A
a)A cross reference marking shall be indicated on
each part packaged separately. This marking is not
required to be permanent and shall be in the form
of a tag or similar temporary marking.
N/A