Energy Guide

Page 95 of 104 Report No.: HK2107050725-SR
UL 507
Clause Requirement + Test Result - Remark Verdict
TRF No. UL507A
b)Each carton containing parts to complete the
appliance shall be marked "For Use Only With
(Manufacturer's name), Model (s) (Name of
Appliance)," or equivalent wording. The carton
containing the motor assembly shall be marked "To
Complete This (Name of Appliance), Parts Are
Shipped In A Separate Carton. Cartons Containing
These Parts Are Marked To Indicate Suitability
With This Model," or equivalent wording.
N/A
80.4.2 Industrial air circulator motor, blade, and grill
assemblies shall not be shipped separately from
the head assembly. When an industrial/commercial
air circulator fan head assembly is shipped
separately from stand/mounting assembly:
N/A
a)The fan and carton shall be marked with the
following, "CAUTION: To Reduce the Risk of
Personal Injury, Use Only With Stand/Mounting
Assembly Models , Manufactured by ."
N/A
b)The stand/mounting assembly and carton shall
be marked with the following: "CAUTION: To
Reduce the Risk of Personal Injury, Use Only
With Fan Head Assembly Model ,
Manufactured by ."
N/A
80.5 Wall- or ceiling-insert fans P
80.5.1 A wall- or ceiling-insert fan that has been found to
be suitable for use in a cooking area may be
marked to indicate that fact. See 112.1.
P
80.5.2 A wall-insert fan or ceiling-insert fan that is not
acceptable for use in a cooking area because the
fan does not comply with the requirements in 19.2,
19.3, 113.1.1, 113.2.1, or 116.1 shall be marked
legibly with any one of the following, or equivalent
wording:
P
80.5.3 Unless equipped with shutters or louvers, or unless
it has been found to comply with the requirements
in 48.1.1, a wall-insert fan intended for commercial
or industrial use – see 48.1.1(d) – shall be marked
"Install behind shutters for protection from rain" or
with an equivalent wording located so that it will be
readily visible after the fan has been installed as
intended.
P
80.5.4 A wall-insert fan intended for mounting in an
interior wall shall be permanently marked where
the marking is readily visible after the fan has been
installed as intended, "Install in interior wall" or with
an equivalent wording.
P