Installation & Assembly

Assembly
Step11:Right roller support assembly
Insert the shaft of roller into roll tube plug,meanwhile insert the torsion bar into the right roller supports with htting
Then tighten the right hexagon bolt by 5mm hexagon wrench.As show in the figure below:
Step12:Assembly to make a whole awning
Make the valance through groove of front bar,pay attention to the directionan make sure the left and right sides on
average,then hitting the cover of front bar into the end of front bar.As show in the figure below:
If the part of front bar is a little deformed,please adjust it with tools by youself.
10
8
16
19
19
6-1
6-2
6-3
19
13-1
13-2
13-2