User Guide

Hardware Installation
How to Connect the Monitor?
Plug your monitor cable into the monitor connector on your AGP graphics
card. Make sure the other end of the monitor cable is properly connected to
your monitor.
Installation Procedures
For the first time Installation
Locate the AGP bus expansion slot, make sure this slot is unobstructed.
1. Remover the corresponding expansion slot cover from the computer chassis.
2. Ground yourself to an anti-static mat or other grounded source.
3. Position the card directly over the AGP slot and insert one end of the card down into the slot. Be sure the
metal contacts on the bottom of the host adapter are securely seated in the slot.
4. Connect your analog monitor's 15-pin VGA connector to the card and fasten the retaining screws (if any).
5. Connect other cables and devices if available.
Now you are ready to install the software drivers and utilities.
For Systems with existing VGA card
Change your display driver to Standard VGA.
1. Shut down your computer and unplug all electrical cards.
2. Replace the existing VGA card with the new graphics card.
3. Restart your computer and install the new display driver.