User Guide

105
A
A
K
K
8
8
9
9
M
M
a
a
x
x
/
/
A
A
K
K
8
8
9
9
-
-
L
L
/
/
A
A
K
K
8
8
9
9
-
-
N
N
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
7. Wait until Windows 2000 finishes installing devices, regional settings, networking settings, components, and final set of tasks,
reboot the system if it is required.
8. See instructions in section 4 to verify controller was installed correctly.
--------------------------------------------------------------------------------------------------
2) Adding the SiI RAID controller to an existing Windows NT 4.0 installation
--------------------------------------------------------------------------------------------------
Follow the instructions in this section to install the Silicon Image SiI 3114 driver on a system already running Windows NT 4.0.
1. Power off the system. Connect the hard drives to the SiI 3114 controller and insert the controller into a PCI slot. Power up
the system.
2. After OS boots up, Click 'Start'
3. Under 'Settings', click 'Control Panel'.
4. Select 'SCSI Adapters' from the Control Panel.
5. Select the 'Drivers' tab and click 'Add'.
6. Click 'Have Disk'.
7. Insert the diskette labeled ' Silicon Image SiI 3114 SATARaid Driver Installation Disk' into A: and press 'Enter'.
8. Choose 'Silicon Image SiI 3114 SATARaid Controller' and click 'OK'.
9. See instructions in section 4 to verify controller was installed correctly.