User Guide

106
A
A
K
K
8
8
9
9
M
M
a
a
x
x
/
/
A
A
K
K
8
8
9
9
-
-
L
L
/
/
A
A
K
K
8
8
9
9
-
-
N
N
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
-----------------------------------------------------------------------------------------------------
3) Adding the SiI RAID controller to an existing Windows 2000/XP installation
-----------------------------------------------------------------------------------------------------
Follow the instructions in this section to install the Silicon Image SiI 3114 driver on a system already running Windows 2000.
1. Power off the system. Connect the hard drives to the SiI 3114 controller and insert the controller into a PCI slot. Power up
the system.
2. During OS boot up, Windows 2000 will display the 'Found New Hardware Wizard'. Click 'Next'.
3. Select 'Search for a suitable driver for my device (Recommended)' and Click 'Next'.
4. Under 'Optional search locations' insure that 'Floppy disk drives' is checked.
5. Insert the diskette labeled 'Silicon Image SiI 3114 SATARaid Driver Installation Disk’ into A: and click 'Next'.
6. When the wizard indicates that it found a driver for the device click 'Next'.
7. If the 'Digital Signature Not Found' dialog appears, click 'Yes' to continue installing the driver.
8. The wizard will now copy the required files to the system and start the driver. After starting the driver the wizard will display a
completion dialog, click 'Finish' to exit the wizard.
9. See instructions in section 4 to verify controller was installed correctly.
---------------------------------------------------------------------------------------
4) Verifying controller installation under Windows NT, 2000 and XP
---------------------------------------------------------------------------------------