User Guide

107
A
A
K
K
8
8
9
9
M
M
a
a
x
x
/
/
A
A
K
K
8
8
9
9
-
-
L
L
/
/
A
A
K
K
8
8
9
9
-
-
N
N
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
Follow the instructions in this section to verify that the controller was installed correctly.
For Windows 2000/XP
1. Right click on 'My Computer' icon, select 'Properties', left click on 'Hardware' tab, and then on 'Device Manager' button.
2. Double click on 'SCSI and RAID Controllers', If there is no yellow '!‘ or '?‘ in front of ‘Silicon Image SiI 3114 SATARaid
Controller', the driver is started correctly.
3. To view information about the devices attached to the controller, use the SiICfg Utility and click on the device from the list.
For Windows NT 4.0
1. Double click on 'My Computer' icon, select 'Control Panel', click on 'SCSI Adapters' icon, 'Silicon Image SiI 3114 SATARaid
Controller' should displayed correctly under 'Device' and 'Driver' tab.
2. To view information about the devices attached to the controller, use the SiICfg Utility and click on the device from the list.
--------------------------------------------------------------------------------------------------------
5) Update SiI RAID driver on Windows NT 4.0 with existing Silicon Image driver
--------------------------------------------------------------------------------------------------------
1. After OS boots up, Click 'Start'
2. Under 'Settings', click 'Control Panel'.
3. Select 'SCSI Adapters' from the Control Panel.