User Guide

108
A
A
K
K
8
8
9
9
M
M
a
a
x
x
/
/
A
A
K
K
8
8
9
9
-
-
L
L
/
/
A
A
K
K
8
8
9
9
-
-
N
N
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
4. Select the 'Drivers' tab and click 'Add'.
5. Click 'Have Disk'.
6. Insert the diskette labeled 'Silicon Image SiI 3114 SATARaid Driver Installation Disk' into A: and press 'Enter'.
7. Choose 'Silicon Image SiI 3114 SATARaid Controller' and click 'OK'.
8. Refer to instructions in section 4 to verify controller was installed correctly.
----------------------------------------------------------------------------------------------------------
6) Update SiI RAID driver on Windows 2000/XP with existing Silicon Image driver
----------------------------------------------------------------------------------------------------------
With the Silicon Image controller already plugged in and the driver already installed. Follow the instructions to update SiI RAID
driver.
1. Right click on 'My Computer' and select 'Properties'. Under the 'System Properties' section, click on 'Hardware' tab, and then
on 'Device Manager' click 'SCSI and RAID Controller’ and right click 'Silicon Image Ultra-133 Medley ATA Raid Controller'.
2. Click ‘Driver’,'Update Driver’ and select 'Search for a suitable driver for my device [Recommended]'. Insert the driver diskette
into floppy drive. Click 'Next' and complete the driver installation.
3. System will go through the enumeration process and install the driver. At the end of the process, click 'Yes' to reboot your
system when necessary.
4. See instructions in section 4 to verify controller was installed correctly.