User Guide

109
A
A
K
K
8
8
9
9
M
M
a
a
x
x
/
/
A
A
K
K
8
8
9
9
-
-
L
L
/
/
A
A
K
K
8
8
9
9
-
-
N
N
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
----------------------------------------------------------------------------------------
7) Windows 98SE and Windows ME Fresh Installation Instructions
----------------------------------------------------------------------------------------
Follow the instructions in this section if you are performing a new installation of Windows 98SE/ME and you wish to boot from a
device attached to the SiI 3114 controller.
You may start up the Windows 98SE/ME installation from CD. If either your Windows 98SE/ME CD or CD-ROM drive is not
bootable, your can start up with floppy diskettes.
1. Power off the system. Connect the hard drives to the SiI RAID controller and insert the controller into a PCI slot. Power up the
system.
2. Put your Windows 98SE/ME CD into the CD-ROM/DVD drive, and the Windows 98SE/ME boot diskette in the floppy drive if
your system cannot boot from the CD.
3. Follow the normal Windows 98SE/ME setup instructions to select your choice for partition and file system.
4. Wait until Windows 98SE/ME finishes installing devices, regional settings, networking settings, components, and final set of
tasks, reboot the system.
5. After the system reboot, right click on 'My Computer' and select 'Properties'. From the 'System Properties’, select 'Device
Manager', right click on the '? PCI RAID controller' and select 'Properties' from the pop-up menu.
6. Click ‘Driver’,'Update Driver’ and select 'Automatic search for a better driver[Recommended]'. Insert the driver diskette into
floppy drive. Click 'Next' and complete the driver installation.
7. System will go through the enumeration process and install the driver. At the end of the process, click ‘Yes’ to reboot your