User Guide

110
A
A
K
K
8
8
9
9
M
M
a
a
x
x
/
/
A
A
K
K
8
8
9
9
-
-
L
L
/
/
A
A
K
K
8
8
9
9
-
-
N
N
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
system.
8. See instructions in section A to verify controller was installed correctly.
-------------------------------------------------------------------------------------------
8) First time installing SiI RAID driver with existing Windows 98SE/ME
-------------------------------------------------------------------------------------------
If you have an existing Windows 98SE/ME system and just obtained a Silicon Image SiI 3114 controller card, you need to run
the update program to install Silicon Image driver. The driver package is located in the Silicon Image driver diskette or the
diskette provided by OEM vendor.
1. Power off the system. Connect the hard drives to the SiI 3114 controller and insert the controller into a PCI slot. Power up
the system.
2. During the system boot up, the Hardware Wizard will display that it found a 'PCI RAID Controller' , click 'Next'. Select 'Search
for the best driver for your device [Recommended]' and click 'Next’.
3. Check the ' Floppy disk drives’ and insert the driver diskette into floppy drive. Click 'Next’.
4. System will go through the enumeration process and install the driver. At the end of the process, Click 'Finish’ to complete the
installation. Reboot the system if your Windows 98SE/ME drive is connected on the SiI RAID Controller.
5. See instructions in section A to verify controller was installed correctly.