Specifications

Threshold -Threshold is used to binarise the image before
reading the barcode. 128 is good for most
situation, if the print is very light user may need to
use a higher threshold value.
The final step in using Image to track barcode is to enable the Enter Board
Serial Number check box in the Load untested PCB for Inspection dialog.
Here is a summary of the steps:
1. Make sure BARCODE.DLL is loaded as extension DLL.
2. Train the barcode as a Device with Reference ID =BARCODE, Algorithm
No=21 and set the Ext. Setup parameters (Number of Characters, Rotation
and Threshold) accordingly.
3. Set the search area for the barcode, and do a Test this Device, to verify
barcode reading.
4. Enable Enter Board Serial Number in Load untested PCB for
Inspection dialog box.