Specifications

Backup Procedures
As with any computer system, periodic backups are very important to ensure
that critical data is not accidentally lost due to system crashes, etc. The
following folders and files should be backed up on a regular basis. Also,
whenever a ScanSpection program is created or modified, it should be backed
up. The default locations for these files and folders are shown below; if your
system differs from these, please make the necessary adjustments. Normally,
the backup procedure that the ScanSpection software offers should be used
for saving the Board Setup files and their respective folders. You will find this
under FILE | SAVE or FILE | SAVE AS. Immediately after creating or
modifying the program, under normal circumstances, use FILE|SAVE. When
backing up the program, use FILE|SAVE AS since this will allow you to back it
up to another drive and/or location. Usually this second drive would be the ZIP
drive. Please be aware that if you do not use the ScanSpection save
procedure, you may not be saving all the necessary files and folders. This is
because the *.Board Setup folder is hidden. The folders and files can be
unhidden by changing the attributes in Win NT EXPLORER. Please also note
that the ScanSpection SAVE procedure does not save or backup the *.INI
files, *.XLS files, and may not save the central libraries, depending on their
locations. Please be aware you may have more than one central library.
If you have any questions on this procedure, please contact Yestek'
support staff for assistance.
AOI BACKUP LIST
C:\PROGRAM FILES\AOI\LVIDEO.INI
C:\PROGRAM FILES\AOI\Scanspection.INI
C:\PROGRAM FILES\AOI\boardname.Board Setup
C:\PROGRAM FILES\AOI\ boardname.Board Setup\*.*
C:\*.XLS
All central libraries
***Note: boardname refers to the specific name you have chosen
for the PCB that you trained and is not the actual name of the file.