Specifications

Appendix II: Drawer Based AOI Scanner Software
Guide
Yestek' low cost vision system the Scanner Based AOI uses the same
application software as the other vision systems.
Training a new Board
Preparing CAD data
Since training board with CAD data is a lot faster than training each Device
manually, users should locate the CAD data for the board and format the data
in preparation for import. All the Yestek AOI system use the same CAD data
format (the CXF format) Preparing CAD data is the same for all Yestek' AOI
systems. Please refer to CAD data Interface for the description of the CAD
data interface and Sample CAD file for an example CXF file.
Define Board Parameter
Board training can only be done in the "Supervisor Mode" of the software. If
you are in "Operator Mode" enter the Supervisor Mode by selecting from the
File menu, Enter Supervisor Mode. The software would prompt for the
password. The default password is "YesTek".
To define board parameters, select from File menu, New Board Setup the
following dialog appear to prompt user to place a board into the drawer of the
machine.
After securing the board in the fixture, close the drawer then press the OK
button, the next dialog will appear.