Specifications

Edit Board Setup
An existing board setup can be modified at any time after its initial creation.
Users can add new Devices, delete existing Devices, or alter the parameters
of an existing Device. The board size can be re-defined, alignment marks can
be re-trained, and its parameters can be altered.
To add a new Device:
1. Position the Image so that the Device is in the field of view.
2. Press the Add Device button and define the Device.
3. Press the OK button on the small ROI dialog.
4. The Set Device Parameter dialog will appear to allow the user to enter the
Device reference
ID.
To delete a Device:
1. Position the Image so that the Device is in the field of view.
2. Point the mouse to the Device and click the right mouse button to pull down
the Device menu.
3. Select Delete this Device from this menu.
On rare occasions the user may need to change the board size definition. To
do so select Positional | Define Board Size from the main menu.
To re-define the alignment marks, select Positional | Define Alignment Mark
from the main menu. The user may also alter the parameters of alignment by
selecting Positional | Edit Alignment Parameters from the main menu. The
Edit Alignment Parameters dialog will appear.