Specifications

Since the top left corner of the biscuit is used for aligning the biscuit during
pasting, while copying from the map view you must make sure that there are
Devices near that corner and that they will show up in the video view during
pasting. If you copy a biscuit like that shown in the following picture, you will
have no way of pasting it correctly.
Also you must position the Image so that the top left (bottom right after
rotating 180 degrees) corner of the destination biscuit appears in the video
view BEFORE pasting. This is because any Image motion after selecting Edit
| Paste Biscuit cancels the biscuit paste operation.
How can one complete the copy and paste operation if the distribution of
components on the board is in such a way that there is no component on the
top left corner within one field of view of the Image? There are a couple of
ways user can get around the limitation. One is by doing two copy-and-pastes.
The other is to create a fictitious Device on the top left corner of the board
before copy and paste. Then delete the Device afterward.
Paste Biscuit Array
This feature allows the quick creation of the Board Setup that compose of
many biscuits (sub-board) in an array. To use this feature, train the master
biscuit, copy the biscuit as described above, and then select Edit from the
main menu, Paste Biscuit Array. The following dialog will display