Specifications

Functions Options
The System Options dialog sets a variety of options. Users can display the
System Options dialog by selecting Functions | Options from the Supervisor
Mode main menu.
Inspection Auto Re-Start
For off-line systems, if the option is enabled, the system will inspect the same
board over and over again. For the in-line systems with conveyor, this option
causes the next board to be fed into the inspect position for inspection. If the
pass only box is checked, inspection will auto start only if the board passes
all of the inspection. This gives the user a chance to review the defect(s) in
case there is an inspection failure. This option can also be turned on or off in
the Result Dialog.
Inspection Abort Limit
This sets a limit for inspection to stop after the specified number of defects is
encountered. This allows the inspection process to quickly stop in case a
board of the wrong type is loaded into the system by mistake.
Device Audit Count
For inline operation, this count allows users to inspect 1 out of x board (e.g. 1
out of 10 board if the count=10). The S/Ns of the board skipped will still be
recorded in the data logger the entry will mark “Skip”.