Specifications

Solder Inspection
The user can define the Solder Inspector only after the Device has been
trained. From the Device pop up menu, there is the selection Define Solder
Inspector. Upon selecting the item, the software prompts the user to draw a
ROI (Region of Interest) around the area where the missing solder condition is
to be detected. After defining the area, the following dialog will display:
From this dialog, the user enters the parameters for the Solder Inspector. The
user need to specify are the joint direction relative to the Device, the preferred
Image for the inspection and whether the joint is from a through hole device.
The algorithm number specifies which inspection algorithm to use for this
solder area. Currently, 1 for pattern recognition and 2 for histogram.
After specifying the area users can activate a pop up menu by placing the
mouse pointer inside the area and depress the right mouse button:
Edit Parameter...
Display the solder Inspector Parameters dialog.
Extended Params...
This selection allows the setting of parameters in the extension DLLs.
Depends on the algorithm used, different dialogs would display. For