Specifications

Algorithm No2 i.e. the histogram analysis can be used to check for
missing or insufficient solder condition. It is fast and effective, as long
as the ROIs are placed precisely on the solder joints. This limits it
effectiveness only to the large to median size discrete devices. To
increase its effectiveness on smaller devices Anchors can be used.
Using Anchors will increase the complexity and make the Board Setup
more difficult to maintain or transfer.
Move/Resize
This function allows gross move or re-size of the solder area.
Align...
Launches an alignment dialog to fine-tune the position of the solder
area.
Delete Solder Inspector
Delete the selected solder area.
Save Solder Image
Save the image of the selected solder area for later neural network
training.
Update Solder
This menu selection set the parameters of all the solder areas on the
board base on the current solder area parameters. This function is
essential while experimenting with parameters on solder areas of
leaded ICs. The software prompts the user for the scope of the update
with the following dialog: