User Guide

5.2 NetWare 3.x/4.x/5.x Installation & Setup
Once your print server is connected to your Ethernet network, you can set it
up for use with your networking software. There are two methods you can
use to do this easily:
Please note that, you need install the IPX protocol before the following
procedure,
1. On DOS environment or DOS box of Windows, use the “INSTALL” quick-
installation program found on the <CD-ROM Drive>\DOSUTIL of CD-ROM
included with the print server.
2. On DOS environment or DOS box of Windows, use the “PSETUP”
configuration program found on the included <CD-ROM Drive>\DOSUTIL,
configure the print server to use a particular file server. Then, use NetWare’ s
PCONSOLE program to create a NetWare print server and print queue with
the appropriate names.
5.2.1 Quick Installation Using “Install” program
The INSTALL program included on the CD-ROM can be used to quickly set up
the print server for use on the NetWare environment. It can only be used to
set up the print server as Printer Server mode; it cannot be used to configure
the print server as Remote Printer mode. It handles changing the print
server’s internal settings, the creation of NetWare print server and print
queue objects on the file server, and the assignment of the print server to the
queue. Unless you need to configure the NetWare settings to conform to
special requirements for your network, you can use the quick installation
method.
To use this method,
1. Log into your NetWare server as SUPERVISOR.
2. Insert the CD-ROM included with the print server, and change to the
appropriate drive and directory. Ex. e:\dosutil\
3. Run the INSTALL program
42