User Guide

spaces (/nt). If the program does not explicitly signal end-of-job, the capture

facility will wait 10 seconds (/ti=10) before assuming that the print job is

complete.

7. Reset the print server to have the changes take effect.

Before printing, you may want to verify that the setup was complete. Using

the Print Server Status option of the PSETUP command (as described in the

following section), you can verify that the print server is connected to the

right file server, is using the correct network frame type, and so on.

You may also want to use the NetWare PCONSOLE program to verify that:

A NetWare print server and one, two or three print queue(s) have been

created on the file server. The number of print queues created is equal to the

number of printer port of your print server.

Printer 0 (or Printer 1, Printer 2) on the print server is serving the new print

queue(s).

The print queue(s) and print server have the right permissions and

notification settings.

For more detailed information, consult your NetWare manual.

5.2.2 Installation Using PSETUP

5.2.2.1 Configuring as Print Server Mode

For more complex setup needs, you can use the PSETUP program in

conjunction with the NetWare PCONSOLE program.

The installation procedure is as follows:

1. From a workstation, log in to your NetWare server as SUPERVISOR.

2. Run the PSETUP program included on the CD-ROM. (Ex.

e:\dosutil\psetup.exe )

3. Select your new print server from the list provided.