User Guide

7.12 DHCP Cfg - DHCP Server Configure
The print server can be configured as DHCP server to provide dynamic IP
addresses assignment. The DHCP Cfg page allows you to set:
The DHCP startup, which determine if the print server will act as DHCP
server. If this item is set to Auto, the print server will detect if there is any
DHCP server on the network when it boots up. If there is no DHCP server on
the network, then the print server will configure itself as DHCP server;
otherwise it will disable this function.
DHCP setup is used to configure TCP/IP parameters that will be assigned to
a DHCP client. If this item is set to Auto, the print server will determine all
TCP/IP parameters automatically; otherwise you will configure the following
parameters:
IP Address: specifies the IP address of print server itself.
Starting IP: specifies the starting IP address for assigning to DHCP clients.
IP range: specifies how many IP addresses are available to DHCP clients.
Gateway IP: gives the IP address of the default gateway.
Netmask: gives the network mask.
DNS server: gives the IP address of the domain name server.
The Write button: save the configuration to the print server.
The Reset button: reset the print server to let the changes take effect.
69