User Guide

The DHCP server startup, which determines if the print server will act as

DHCP server. If this item is set to Auto, the print server will detect if there is

any other DHCP server on the network when it boots up. If there is no DHCP

server on the network, then the print server will configure itself as DHCP

server; otherwise it will disable this function.

DHCP setting is used to configure TCP/IP parameters that will be assigned to

a DHCP client. If this item is set to Auto, the print server will determine all

TCP/IP parameters automatically; otherwise you will configure the following

parameters:

Starting IP: specifies the starting IP address for assigning to DHCP clients.

IP range: specifies how many IP addresses are available to DHCP clients.

Net mask: gives the network mask.

Gateway IP: gives the IP address of the default gateway.

DNS server: gives the IP address of the domain name server.

The Save to Print Server button: save the configuration to the print server.

Make sure to reset the print server (described in section 8.3.11) to

have the changes take effect.