User Guide

7
100Base-FX Module Installation
To install any of the modules: (Includes SC or ST type
connectors)
1. Locate the module slot in the switch’ s rear panel.
2. Using a screwdriver, undo the two screws and remove the
dust cover on the module slot.
3. Holding the module component-side up and connector-side
in, gently slide the module along the guides and seat it in
the internal connector.
4. Using a screwdriver, replace the two screws and tighten
until snug.
We recommend that you retain the dust cover in case you need
to remove the module for an extended period sometime in the
future.
For AOW-216 (16-port switch), port 9 and the 100BASE-FX port