User Guide

Hardware Installation
2-12
2.3 Connectors
2.3.1 Power Cable
A standard baby AT (PS/2) power supply has two cables with six wires on each.
Plug in these cables to the onboard power connector in such a way that all the
black wires are in the center. The power connector is marked as PWR1 on the
system board.
Caution: Make sure that the power supply is
off before connecting or disconnecting the
power cable.
Black wire (GND)
Red wire (+5V)
PWR1
2.3.2 CPU Fan
Plug in the fan cable to the two-pin fan connector onboard. The fan
connector is marked FAN on the system board.
+12VGND
FAN
GND