AP5T User's Guide Printed in Taiwan PART NO.: 49.87901.011 DOC. NO.
AP5T Mainboard User's Guide Document Number : AP5T-3-E9711L Model and Revision : For AP5T revision 3.xx Manual Version : English, revision L Release Date : Nov 5, 1997 More help for latest information: Taiwan http://www.aopen.com.tw USA http://www.aopen-usa.com http://www.aopenamerica.com Europe http://www.aopen.
Copyright Copyright 1997 by this company. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, manual or otherwise, without the prior written permission of this company.
Disclaimer This company makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any software described in this manual is sold or licensed "as is".
FCC Class B Radio Frequency Declaration of Conformity This equipment has been tested and found to comply with the limits for a Class B Subassembly -CPU Board device, pursuant to Part 15 of FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
Notice 1: The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Notice 2: Shielded interface cables, if any, must be used in order to comply with emission limits.
Purpose and Scope This manual tells how to install and configure the system board. Organization This manual consists of three chapters and one appendix: Chapter 1, Overview, covers the introduction and specifications of the system board. Chapter 2, Hardware Installation, describes hardware jumpers, connectors and memory configuration. There are user friendly drawings to locate jumper and connector.
Conventions The following conventions are used in this manual: Text entered by user, default settings, recommended selections Represent text input by the user, default settings and recommended selections , ,, , , etc Represent the actual keys that you have to press on the keyboard. , Note: Gives bits and pieces of additional information related to the current topic. Warning: Alerts you to any damage that might result from doing or not doing specific actions.
CONTENTS CHAPTER 1 1.1 OVERVIEW SPECIFICATIONS .............................................................1-3 CHAPTER 2 HARDWARE INSTALLATION 2.1 JUMPER AND CONNECTOR LOCATIONS ............................2-2 2.2 JUMPERS .......................................................................2-4 2.2.1 .......................................Setting the CPU Voltage...................2-5 2.2.2 ...................................... Selecting the CPU Frequency...........2-6 2.2.
3.6 3.7 3.8 3.9 3.10 3.11 3.12 3.13 3.14 3.15 3.16 PNP/PCI CONFIGURATION SETUP .................................3-23 LOAD SETUP DEFAULT .................................................3-26 LOAD TURBO DEFAULT.................................................3-27 INTEGRATED PERIPHERALS ...........................................3-28 PASSWORD SETTING ....................................................3-33 IDE HDD AUTO DETECTION .........................................3-34 SAVE & EXIT SETUP .................
APPENDIX C TROUBLESHOOTING APPENDIX D AOPEN BEST PRODUCTS x
