User Guide

AMI BIOS Utility
3-10
Floppy Drive Swap
This parameter allows you to swap floppy drives. For example, if you have two
floppy drives (A and B), you can assign the first drive as drive B and the
second drive as drive A or vice-versa. Disable the parameter to bypass the
function. The default is Disabled.
Floppy Drive Seek
When enabled, BIOS detects whether there is a floppy disk drive installed in
the system. Disable the parameter to skip the function.
Typematic Rate
This parameter allows you to control the speed at which the system registers
repeated keystrokes.
System Keyboard
Set this parameter to Present if there is a keyboard connected to the
system. If none, select Absent.
Primary Display
This function specifies the VGA type in use. The selections are VGA/EGA,
CGA 40 x 25, CGA 80 x 25, Mono, and Absent. The
default setting is VGA/EGA.
Password Check
This parameter lets you set when to check for the password. When set to
Always, a password prompt appears every time you turn on the computer
and when you enter Setup. When set to Setup, the password prompt
appears when you try to enter setup. The Optimal and Turbo default setting is
Setup.
OS/2 Compatible Mode
Enable the parameter if your system is utilizing an OS/2 operating system and
has a memory size of more than 64 MB. Otherwise, set this to Disabled.
The default setting is Disabled.