User Guide

AMI BIOS Utility
3-20
PCI IRQ Priority Auto Setting
Set this parameter to Yes to automatically set the appropriate available
interrupt for each PCI slot. Select No if you prefer to manually set the
interrupts.
1st, 2nd, 3rd, and 4th Available IRQ
These parameters are configurable only if the PCI IRQ Priority Auto Setting
parameter is set to No. When configurable, these let you specify the ranking
of the interrupts which you can assign to the PCI devices installed in your
system.
PCI VGA Palette Snoop
PCI devices support the palette snooping technique that enables the device to
control access to their palette registers. Enable this parameter to activate the
palette snooping function in the PCI VGA devices installed in the system.
Check your VGA card manual for more information about his function. The
default setting is Disabled.
PCI IDE Card
This function allows you to select the PCI slot(s) that you want to enable, if
there is any offboard PCI IDE card present. Set this parameter to Auto to
automatically configure the installed PCI card.
PCI IDE Primary IRQ
This parameter lets you assign an IRQ for the IDE device connected to your
primary IDE connector. The options are INTA, INTB, INTC, INTD,
Hardwired and Disabled. If the PCI IDE Card parameter is set to
Auto, this parameter becomes non-configurable.
PCI IDE Secondary IRQ
This parameter lets you assign an IRQ for the IDE device connected to your
secondary IDE connector. The options are INTA, INTB, INTC,
INTD, Hardwired and Disabled. If the PCI IDE Card parameter is
set to Auto, this parameter becomes non-configurable.