User Guide

AMI BIOS Utility
3-23
• HPSIR - Select this setting only if the InfraRed (IR) function is
activated (i.e., an IR module is installed in your system). This setting
allows infrared serial communication at a maximum baud rate of 115K
baud.
• ASKIR - Select this setting only if the IR function is activated (i.e., an
IR module is installed in your system). This setting allows infrared serial
communication at a maximum baud rate of 19.2K baud.
Onboard Parallel Port
This parameter allows you to select the address for the parallel port. The
available settings are Auto, 378h, 278h, 3BCh, and
Disabled. Selecting Disabled deactivates the parallel port.
PARALLEL PORT IRQ
This parameter allows you to set the interrupt for the parallel port. The default
setting is 7.
PARALLEL PORT MODE
This parameter specifies the parallel port mode. The mode options are SPP,
EPP, and ECP. The default is SPP.
Onboard IDE
This parameter enables or disables the IDE device(s) connected to your
system. The selections are Primary, Secondary, Both, and
Disabled.