User Guide

Hardware Installation
2-6
6. Plug the fan cable onto the two-pin
fan connector onboard. The fan
connector is marked JP10 on the
system board. If your fan cable has
four pins, plug it onto the power
connector.
2-pin fan power connector (J2)
GND
7. Set jumper JP7 according to the
CPU type currently installed on
your board.
CPU TYPE SELECT
8. Set jumpers JP2, CN13 and CN14
according to the frequency
supported by the CPU currently
installed on your board.
GND
JP2 CN13 CN14
+12V
150 MHz
166 MHz
180 MHz
200 MHz
CPU VOLTAGE
JP7
Standard CPU
OverDrive CPU