User`s manual

Setting-Up the Office Server in Interactive Mode
AXEL Office Server 13
An administrator switch is located on the Office Server rear panel. To enable
set-up mode press then release this switch.
The set-up main menu is displayed on the character terminal.
The following section describes the use of set-up mode.
When the set-up session has been completed, the admin port can be used for
other network services.
Note: during set-up mode, the two leds of the admin port remain lit. For the
AX4020, the "conf." led is also lit.
2.1.2 - From a telnet Session
To run set-up within a telnet session, the IP address of the Office Server must
already be set. This can be done either:
- through a serial terminal, plugged into the admin port (see chapter 2.1.1),
or
- by specific embedded protocols, using the Ethernet address (see
appendix A.6).
Run the telnet session from any network host. Use 4096 as the telnet port. For
example: under UNIX (where name is the Office Server hostname):
$ telnet name 4096 <CR>
The set-up main menu will then display on the console.
The following section describes the use of set-up mode.
When the set-up session has been completed, the Office Server automatically
terminates the telnet session.