User Guide

Hardware Installation
2-19
Other housings may have a 12-pin
connector. If your housing has this
type of connector, connect it to
PANEL as shown in the figure.
Make sure that the red wire of the
connector is connected to +5V.
1
+5V
11
10 20
PANEL
Note: If your housing comes with Turbo switch and Turbo
LED connectors, you may use these connectors for
Suspend switch and Green mode LED functions,
respectively.
Caution:. If you use toggle mode Turbo switch as
Suspend switch, be sure to push it twice to simulate
momentary mode. Otherwise the system may hang or fail
to reboot because you always force it to suspend.
2.3.13 IrDA Connector
Serial port 2 can be configured to support wireless infrared module, with this
module and application software such as Laplink, user can transfer files to or
from laptops, notebooks, PDA and printers. This mainboard supports IrDA
(115Kbps, 1 meter) as well as ASK-IR (19.2Kbps).
Install infrared module onto IrDA
connector and enable infrared function
from BIOS setup, make sure to have
correct orientation when you plug onto
IrDA connector.
Pin
1
2
3
4
5
6
Description
+5V
NC
IRRX
GND
IRTX
+3.3V
Note: Onboard serial port 2 (COM2) will not be
available after IrDA connector is enabled.