User Guide

Hardware Installation
2-15
For Dallas DS12B887, BENCHMARQ bq3287AMT, or SGS ST M48T86 PCI
chip:
1. Turn off the system power.
2. Locate JP10 and short pins 1-2 for a few seconds. Check your manual
for the correct jumper settings and location of the jumpers.
3. Turn on the system power.
4. Turn off the system power again.
5. Reset JP10 to its normal setting by shorting pins 2-3.
6. Turn on the system power .
7. Press
during bootup to enter the BIOS Setup Utility and specify a
new password, if needed.