User Guide

Hardware Installation
2-21
2.9.8 Front-panel Switches and LEDs
HDD LED
The HDD LED connector is marked
JP15 on the board. Plug in the HDD
LED cable to this four-pin connector.
See the figure.
Multifunction Connector
The multifunction connector is a 20-pin
connector marked JP23 on the board.
Attach the green mode LED, software
power switch, reset switch, break switch,
and speaker connectors to its
corresponding pins on the connector as
shown in the figure.
( Turbo Switch ) ( Turbo LED )
Break Switch Green Mode LEDReset
Speaker Power LED Keylock
2.9.9 Keyboard
To connect a PS/2 keyboard, plug in the
PS/2 keyboard cable to the PS/2
keyboard connector marked CN3 on the
system board .
Software Power
S
wi
tc
h