User Guide

Hardware Installation
2-4
2.2 Jumpers
Jumpers are made by pin headers and plastic connecting caps for the
purpose of customizing your hardware. Doing so requires basic knowledge of
computer hardware, be sure you understand the meaning of the jumpers
before you change any setting. The onboard jumpers are normally set to their
default with optimized settings.
On the mainboard, normally there is a bold line marked beside pin 1 of the
jumper, sometimes, there are numbers also. If we connect (short) plastic cap
to pin 1 and 2, we will say set it at 1-2, and when we say jumper is open, that
means no plastic cap connected to jumper pins.
1
2
Open
1
2
Short
1
2
3
Jumper set at 1-
2
1
2
3
Jumper set at 2-3