User Guide

Hardware Installation
-- E-8 --
Rear Panel
Ÿ Power Connector
Used to connect to the host computer’s power supply (DC 5V/12V).
Be careful not to reverse the pow
er connector when attaching it. A
reversed connection may cause damage to the equipment (not
covered by the warranty)
Ÿ E-IDE Connector
Use a 40-pin double-end flat E-IDE cable to connect to the E-IDE interface.
Connecting or disconnecting connectors while power is on may result
in a short circuit, causing damage to the equipment. When connecting
or disconnecting connectors, make sure to turn off the power
beforehand.
Ÿ Audio Output Connector
Used to connect the sound card (analog signal).
Ÿ Digital Audio Output
Used to connect the sound card (digital signal).
Ÿ ATA mode setting Jumper (Optional)
The drive is set on “PIO mode 4” by default. You can set your drive on “UDMA ”
mode by remove the jumper.
Note: The compatibility of UDMA function is interrelated
with the chipsets of motherboard. If error occurs when
drive is writing after you s
et on UDMA mode, please plug
jumper back to set drive on PIO mode.