User Guide

10
Caution: Be careful not to reverse the poser connector when
attaching it. A reversed connection may cause damage to
the equipment (not covered by the warranty).
3.7 SCSI connector
Use a 50 pin double-end flat SCSI cable to connect to the SCSI interface.
Caution: Connecting or disconnecting connectors while
power is on may result in a short circuit, causing damage to
the equipment. When connecting or disconnecting
connectors, make sure to turn off the power beforehand.
3.8 Audio Output Connector
Used to connect to the sound card.
3.9 SCSI ID Jumper
Used when selecting the SCSI ID number. Don't use jumpers to change
anything besides the SCSI ID, but keep the drive as initially set (no jumper
pins: ID 0). SCSI ID changes become valid after power is turned off, then
on again.
Caution: Installing jumper pins besides the ones for SCSI ID
settings may be the cuse of damage or abnormal drive
operation.