User Guide

Table 2-2 SCSI ID

SCSI ID Pin No. 2 Pin No. 3 Pin No. 4 Remark

0 OFF OFF OFF Factory setting

1 ON OFF OFF

2 OFF ON OFF

3 ON ON OFF

4 OFF OFF ON

5 ON OFF ON

6 OFF ON ON

7 ON ON ON *1

Note ON : Jumper Pin is attached

OFF: Jumper Pin is not attached

*1: Don' t use this setting. It is located as the setting for SCSI Adapter Card

usually.

4. Installation

This drive is for setting horizontally. Also, for the angle of the setting

position, make sure it is based on the specification.

By setting the unit out of the specification, the function may operate

incorrectly.

Installation Conditions:

Mounting direction Horizontal

Installation Angle ± 15

or less