User Guide

2
moisten a cloth with neutral detergent diluted with water
and use it to clean particularly dirty areas.
q Don' t cutoff the electric power while the drive is
operating.
q When connecting the SCSI cable, observe the following
points.
q If two different devices with the same SCSI ID are
connected to the SCSI bus, the system may fail to
function. Be careful that none of the SCSI Ids are the
same when installing the equipment.
q Keep the total length of the SCSI cable within 6 meters.
q When connecting the SCSI cable to the drive, make sure
the power is OFF.
q Never insert a damaged disc into the drive.
q In wintertime, don' t use a disc soon after bringing in
from outdoors. Use it only after it has reached room
temperature.
3. Cautions Concerning Disc Cleaning
q Remove the disc by pressing the eject button.
q Use compressed air to clear dust from the drive. (Spray the
compressed air for about 5 seconds).
q Check to see if there is dirt on the surface of the disc. Be careful not to
touch the disc with the fingers when doing this.
q After cleaning the disc with compressed air, place it on the disc tray
and load in the drive.
*We suggest using Perfect Duster II (50z.) as compressed air for cleaning.