Specifications

EQUIPMENT HANDLING PROCEDURES Document No. DER01422

Effective Date 30 Aug 07 Page 3 of 3

EQUIPMENT STORAGE

General

If equipment is not being installed immediately, it should be stored in a dry environment (50

percent relative humidity or less). A dry environment will ensure that the machine remains in the

same condition as when it was received.

If unit is stored outdoors, cover with a UV-resistant tarpaulin (tarp) or UV-resistant shrink-wrap.

Install vents when using shrink-wrap. Cap exposed solid and liquid discharge chutes and feed

component to prevent entry of moisture or foreign matter. Seal the Operating and Maintenance

manual in plastic and attach to unit.

WARNING! MOTOR MAY BE DAMAGED BY STORING MACHINE IN A HIGH

HUMIDITY ENVIRONMENT (GREATER THAN 50% RH). OUT-OF-SERVICE

MOTOR(S) MUST BE STORED IN A LOW-HUMIDITY ENVIRONMENT.

Bearings

The main bearings that support the bowl assembly and the conveyor bearings should be

lubricated before the centrifuge is placed in storage using the grease specified

DER05023.

Locations of lubrication points are shown in Figure 5023-1 in Section 5.

The content of this document is subject to change at any time. Information provided does not cover all details or variations possible

with DERRICK equipment; nor does it cover every contingency that may be met during installation, operation, maintenance, or

troubleshooting of the equipment. If additional information is required, or should situations arise that are not covered by this manual,

bring the matter to the attention of your local DERRICK representative or the Service Department at DERRICK Corporation in

Buffalo, New York.