Specifications

MATERIAL SAFETY DATA SHEET
The information contained herein is based on data available at the time of preparation of this data sheet which ICI Paints believes to be reliable. However, no warranty is expressed or implied regarding the accuracy of this
data. ICI Paints shall not be responsible for the use of this information, or of any product, method or apparatus mentioned and you must make your own determination of its suitability and completeness for your own use,
for the protection of the environment, and the health and safety of your employees and the users of this material.
Complies with OSHA hazard communication standard 29CFR1910.1200.
prepared 05/06/08
DEVTHANE 359 DERRICK GREEN
359D
ICI Paints North America 15885 Sprague Road Strongsville, Ohio 44136 EMERGENCY TELEPHONE NO. [phone]
HAZARDS IDENTIFICATION (ANSI Section 3)
Primary route(s) of exposure : Inhalation, skin contact, eye contact, ingestion.
Effects of overexposure :
Inhalation : Irritation of respiratory tract. Prolonged inhalation may lead to. Inhalation of spray mist
may cause irritation of respiratory tract. Mucous membrane irritation, fatigue, drowsiness,
dizziness and/or lightheadedness, headache, uncoordination, nausea, vomiting, abdominal pain,
chest pain, coughing, apathy, central nervous system depression, intoxication, anesthetic effect
or narcosis, difficulty of breathing, allergic response, tremors, severe lung irritation or damage,
pulmonary edema, pneumoconiosis, loss of consciousness, respiratory failure, death. Possible
sensitization to respiratory tract.
Skin contact : Irritation of skin. Prolonged or repeated contact can cause dermatitis, defatting, severe
skin irritation. Possible sensitization to skin.
Eye contact : Irritation of eyes. Prolonged or repeated contact can cause conjunctivitis, blurred vision,
tearing of eyes, redness of eyes, severe eye irritation, corneal injury.
Ingestion : Ingestion may cause lung inflammation and damage due to aspiration of material into
lungs, mouth and throat irritation, drowsiness, dizziness and/or lightheadedness, headache,
uncoordination, nausea, vomiting, diarrhea, gastro-intestinal disturbances, abdominal pain,
visual disturbances, apathy, central nervous system depression, intoxication, anesthetic effect or
narcosis, burns of the mouth, throat, stomach, pulmonary edema, loss of consciousness,
respiratory failure, death.
Medical conditions aggravated by exposure : Eye, skin, respiratory disorders, kidney disorders, liver
disorders, nervous system disorders, respiratory disorders.
FIRST-AID MEASURES (ANSI Section 4)
Inhalation : Remove to fresh air. Restore and support continued breathing. Get emergency medical
attention. Have trained person give oxygen if necessary. Get medical help for any breathing
difficulty. Remove to fresh air if inhalation causes eye watering, headaches, dizziness, or other
discomfort.
Skin contact : Wash thoroughly with soap and water. If any product remains, gently rub petroleum
jelly, vegetable or mineral/baby oil onto skin. Repeated applications may be needed. Remove
contaminated clothing. Wash contaminated clothing before re-use. Dispose of contaminated
leather items, such as shoes and belts. If irritation occurs, consult a physician.
Eye contact : Flush immediately with large amounts of water, especially under lids for at least 15
minutes. If irritation or other effects persist, obtain medical treatment.
Ingestion : If swallowed, obtain medical treatment immediately.
FIRE-FIGHTING MEASURES (ANSI Section 5)
Fire extinguishing media : Dry chemical or foam water fog. Carbon dioxide. Closed containers may
explode when exposed to extreme heat or fire. Vapors may ignite explosively at ambient
temperatures. Vapors are heavier than air and may travel long distances to a source of ignition and
flash back. Vapors can form explosive mixtures in air at elevated temperatures. Closed containers
may burst if exposed to extreme heat or fire. Dust explosion hazard. May decompose under fire
conditions emitting irritant and/or toxic gases.
Fire fighting procedures : Water may be used to cool and protect exposed containers. Firefighters
should use full protective clothing, eye protection, and self-contained breathing apparatus. Self-
contained breathing apparatus recommended.
Hazardous decomposition or combustion products : Carbon monoxide, carbon dioxide, oxides of
nitrogen, oxides of sulfur, ammonia, hydrogen chloride, toxic gases, barium compounds. Cyanides.
ACCIDENTAL RELEASE MEASURES (ANSI Section 6)
Steps to be taken in case material is released or spilled : Comply with all applicable health and
environmental regulations. Eliminate all sources of ignition. Ventilate area. Ventilate area with
explosion-proof equipment. Spills may be collected with absorbent materials. Use non-sparking
tools. Evacuate all unnecessary personnel. Place collected material in proper container. Complete
personal protective equipment must be used during cleanup. Large spills - shut off leak if safe to do
so. Dike and contain spill. Pump to storage or salvage vessels. Use absorbent to pick up excess
residue. Keep salvageable material and rinse water out of sewers and water courses. Small spills -
use absorbent to pick up residue and dispose of properly.
HANDLING AND STORAGE (ANSI Section 7)
Handling and storage : Store below 80f. Store below 100f (38c). Keep away from heat, sparks and
open flame. Store in original container. Keep away from direct sunlight, heat and all sources of
ignition. Keep container tightly closed in a well-ventilated area.
Other precautions : Use only with adequate ventilation. Do not take internally. Keep out of reach of
children. Avoid contact with skin and eyes, and breathing of vapors. Wash hands thoroughly after
handling, especially before eating or smoking. Keep containers tightly closed and upright when not
in use. Empty containers may contain hazardous residues. Ground equipment when transferring to
prevent accumulation of static charge.
EXPOSURE CONTROLS/PERSONAL PROTECTION (ANSI Section 8)
Respiratory protection : Respiratory protection is required for use in isocyanate containing
environments. Consider type of application and environmental concentrations when selecting
respiratory protection. Observe governmental regulations for respirator use. (29 CFR
1910.134(OSHA))(Canadian z94.4) The use of positive pressure supplied air respirator is
mandatory when the airborne isocyanate concentrations are not known. Note: isocyanate based
materials have been determined to cause allergic sensitization in humans. Avoid inhalation and
dermal (skin) contact with the uncured material.
Ventilation : Provide dilution ventilation or local exhaust to prevent build-up of vapors. Use explosion-
proof equipment. Use non-sparking equipment.
Personal protective equipment : Eye wash, safety shower, safety glasses or goggles. Impervious
gloves, impervious clothing, face shield, apron, boots.
STABILITY AND REACTIVITY (ANSI Section 10)
Under normal conditions : Stable see section 5 fire fighting measures
Materials to avoid : Oxidizers, acids, reducing agents, bases, aldehydes, halogens, amines, alkalis,
water, peroxides, nitric acid, alcohols, combustible materials, caustics, mineral acids. Nitrates.
Conditions to avoid : Sunlight, elevated temperatures, moisture, contact with oxidizing agent, storage
near acids, sparks, open flame, ignition sources.
Hazardous polymerization : Will not occur