Specifications

INSTALLATION INSTRUCTIONS Document No. DER03022

Effective Date 23 Dec 08 Page 15 of 15

SENSOR CONNECTIONS (CONT’D)

Figure 3022-12 Sensor System Plug Connections

COMPRESSED AIR CONNECTION TO PURGE SYSTEM

For explosion-proof Control Cabinet, supply compressed air at the required pressure and flow rate

to the purge control unit. Connect compressed air supply in accordance with the Expo

Technologies MiniPurge documentation in Section 12.

MACHINE STARTUP

Refer to Section 4 of this manual for initial startup and operating procedures for the centrifuge.

WARNING! DO NOT ATTEMPT TO OPERATE MACHINE WITH SHIPPING

COMPONENTS INSTALLED.

The content of this document is subject to change at any time. Information provided does not cover all details or variations possible

with DERRICK equipment; nor does it cover every contingency that may be met during installation, operation, maintenance, or

troubleshooting of the equipment. If additional information is required, or should situations arise that are not covered by this manual,

bring the matter to the attention of your local DERRICK representative or the Service Department at DERRICK Corporation in

Buffalo, New York.