User Guide

4
Master/Slave Jumper
Cable Select Slave
Master
NOTE: Normally, the red edge of the IDE cable corresponds to pin 1 of the IDE
interface on the DVD-ROM drive.
NOTE: The DVD-ROM drive supports Ultra DMA/33 mode to improve IDE data
transfer rate. To implement this function, you also need to make sure your
motherboard supports UDMA mode and the bus master IDE driver has been
installed properly.
U
U
s
s
i
i
n
n
g
g
t
t
h
h
e
e
D
D
V
V
D
D
-
-
R
R
O
O
M
M
D
D
r
r
i
i
v
v
e
e
In most cases, software applications that utilize DVD-ROM drives control the DVD-
ROM drive operations directly. However, you can control the drive manually using the
front-panel controls.
1. Headphone Jack
2. Power-on/Busy LED
3. Emergency-eject Hole
4. Load/Eject Button
5. Volume Control
6. Disc Tray
E
E
m
m
e
e
r
r
g
g
e
e
n
n
c
c
y
y
-
-
e
e
j
j
e
e
c
c
t
t
O
O
p
p
t
t
i
i
o
o
n
n
1. Locate the tiny hole at the bottom of the
disc tray. Gently poke the hole with a
sharp needle or a clip.
2. When the disc tray opens, pull out the tray
and remove the disc from the DVD-ROM
drive.