User Guide

Open
A
93
F
F
o
o
r
r
t
t
r
r
e
e
s
s
s
s
9
9
1
1
0
0
0
0
O
O
n
n
l
l
i
i
n
n
e
e
M
M
a
a
n
n
u
u
a
a
l
l
A parameter with an asterisk (*) mark indicates that the
parameter appears only when you are using in the Advanced
Level. See “Entering Setup” on Page
2.6.1 Power Management Mode
Power
Management
Mode
Enabled (Default)
Disabled
This parameter allows you to reduce power consumption.
When this parameter is set to “Enabled”, you can configure the
IDE hard disk and system timers. Setting it to “Disabled”
deactivates the power-management feature and its timers.
2.6.1.1 IDE Hard Disk Standby Timer
IDE Hard Disk
Standby Timer
Off (Default)
1 to 15min
This parameter allows the hard disk to enter standby mode after
inactivity of 1 to 15 minutes, depending on your setting. When
you access the hard disk again, allow 3 to 5 seconds (depending
on the hard disk) for the disk to return to normal speed. Set this
parameter to “Off” if your hard disk does not support this
function.