User Guide

Connect IDE cable
It would be easier to carry out the procedure if the IDE cable is properly plugged before
locking up the hard disk to the frame. You can distinguish IDE cable from left and right.
Normally, a standard cable has a foolproof device, which is a small salient on the cable, and a
small dent in the socket. Just aim the salient at the dent and then plug it in.
The first pin is close to
power connector.
What if there is no foolproof device
on the cable?
If you happen to have a cable without foolproof
design, just remember that the first pin is next to the
red line and it would be safe to locate the first pin
close to the power cord
Lock the hard disk in the frame
Use a cross screwdriver to disassemble the hard disk frame from the housing in order to easily
lock the hard disk. After loosing screws, lift the hard disk frame and push it to the direction
where arrow shows to draw it out.
2-8
Start To Handle