User Guide

Power ON Function: This item is used to select Wake on Keyboard/Mouse mode.

z Any Key: This function allows you wake up the system by clicking any

key.

z Button Only: Disable Wake on KB/MS function. You can boot up your

system by power button only.

z Keyboard 98: If selecting this option, you can boot up the system by

power button and the “Wake” key on Keyboard 98.

z Password: Disable the function of power button and let the system can

only be powered on through the preset keys (like a password).

z Hot Key: If selecting this option, you also need to specify the hot key

from “Hot Key Power On” item.

z Mouse Left: This function allows you wake up the system by clicking left

mouse button twice successively.

Note:

 Whenever you change this item, it will only take effect after you

restart the system and successfully boot the Windows or DOS.

 Wake on Mouse function applies to PS/2 mouse only.

 If you set a password but forget it, please clear CMOS.

 If you want to use Wake on Mouse function in DOS, it is necessary to

install the DOS driver of the mouse.

z Mouse Right: This function allows you wake up the system by clicking

right mouse button twice successively.

KB Power ON Password: You can specify 1-5 keys as a password.

Hot Key Power On: If you select “Hot Key” option in “Power On Function”

Item, you need to specify a hot key here.

Onboard FDC Controller:

Setting this parameter to “Enabled“ allowing you

to connect your floppy disk drives to the onboard floppy disk connector

instead of a separate controller card. Change the setting to Disabled if you

want to use a separate controller card.

Onboard Serial Port 1:

This item allows you to assign address and interrupt

for the board serial port. The default is “Auto”.

Onboard Serial Port 2:

This item allows you to assign address and interrupt

for the board serial port. The default is “Auto”.

UART Mode Select: This item is configurable only if the "

Onboard Serial Port

is enabled. This allows you to specify the mode of serial port2. Available

options:

z Normal:

Sets serial port 2 to operate in normal mode. This is the default

setting.

z IrDA (SIR): This setting allows infrared serial communication at a

maximum baud rate of 115.2K baud.