User Guide

51
Note:
 Whenever you change this item, it will only take effect after you restart
the system and successfully boot the Windows or DOS.
 Wake on Mouse function applies to PS/2 mouse only.
 If you set a password but forget it, please clear CMOS.
If you want to use Wake on Mouse function in DOS, it is necessary to install
the DOS driver of the mouse.
Integrated peripherals > SuperIO Device
This item allows you to set SuperIO device.
Power ON Function: This item is used to select Wake on Keyboard/Mouse mode.
z Password: Disable the function of power button and let the system can
only be powered on through the preset keys (like a password).
z Hot Key: If selecting this option, you also need to specify the hot key
from “Hot Key Power On” item.
z Any Key: This function allows you wake up the system by clicking any
key.
z Button Only: Disable Wake on KB/MS function. You can boot up your
system by power button only.
KB Power ON Password: You can specify 1-5 keys as a password.
Hot Key Power On: If you select “Hot Key” option in “Power On Function”
Item, you need to specify a hot key here.
Onboard FDC Controller:
Setting this parameter to “Enabled“ allowing you
to connect your floppy disk drives to the onboard floppy disk connector
instead of a separate controller card. Change the setting to Disabled if you
want to use a separate controller card.
Onboard Serial Port 1:
This item allows you to assign address and interrupt
for the board serial port. The default is “Auto”.