User Guide

Quick configuration is designed to help users with limited network knowledge to
setup the SOHO router and connect to the internet with ease within the least amount
of time.
To start quick configuration for the internet, enter qconfig at the command prompt.
An example of the quick configuration screen is displayed as shown below.
At this point the unit is configured. It is suggested to save the configuration
immediately to keep it in the EPROM. The user can connect and start surfing the
internet by entering the following command.
By using qconfig you can change the telephone number and connect to any specified
destination or ISP manually. For detailed significance of the above command,
please see the following command set.
Note: The quick configuration can only be executed in CLI mode.
Quick Configuration Setup (ESC, ESC to exit)
--------------------------------
IP address of this unit's LAN port : 123.97.35.7
IP mask of this unit's LAN port : 255.255.255.0
Switch Type (etsi, ni1, ntt) : ni1
DN1 : 3930219
DN2 : 3930237
SPID1 : 50839302190101
SPID2 : 50839302370101
Phone number of the remote unit : 8398111
User's ID to log into remote site : john
User's password to log into remote site : master
CLI> config save
CLI> connect john (user entered)
CLI> B1 channel up (automatic display by router)
CLI> add net (automatic display by router)
CLI> config ip nat add isdn (user entered)