User Guide

ISDN Router Manual V.1.1
19
Entering Command
There are two ways to enter commands to configure the router.
1. Enter multiple commands at the top level and terminate with a carriage return.
2. Enter a single command (one token) at the top level followed by a carriage return and goes
down one level of menu at a time until the desired command is completed. At each level, the
user can type help or ? to get a complete list of command for that particular level.
Example:
To configure the ethernet interface with the IP address 192.168.70.1 and with the subnet mask of
255.255.255.0
Method 1:
CLI> ?
? config connect date exit flash help hwinfo
log menu ping reset show trace version
CLI> help
? -- Display menu options
config -- Change the configuration
connect -- Start a PPP connection
date -- Set the date
exit -- Exit the current session
flash -- Operations on the flash-based file system
help -- Display this help
hwinfo -- Display hardware information
log -- Operations on the log
menu -- Run the menu-based configuration
ping -- Ping an IP interface
reset -- Reboot the box with option to save the current configuration
show -- Display configurations and statistics
trace -- Set and display software trace configuration
version -- Display the software and firmware version
CLI> config interface ether ip address 192.168.70.1 255.255.255.0
CLI>