User Guide

ISDN Router Manual V.1.1
42
5.13 Router Test Setup Procedure with NAT
The following figure is used as an example to illustrate how to connect the router to various
network components and configure the router:
Connect all the network components as shown in the figure.
After loading up the AT command interface on your PC, which has the IP address 129.97.35.58, the
router can be configured as follows:
Type at: to go to config mode.
Console login: admin
Password: admin
On the router command line interface:
CLI> config int ether ip add 129.97.35.1 255.255.255.0
Add user “john”, password “master”, and phone number “3840001”:
CLI> config int isdn ppp add user john pass master phone [phone]
If the user “john” already exists then type:
CLI> config int isdn ppp set user john pass master phone [phone]
PC
Router
Total Control
Hub
Server
ISDN
LAN1
LAN2
129.97.35.0
129.97.34.0
129.97.35.58
129.97.34.1
.1 192.168.1.2
192.168.1.1
.100