User Guide

ISDN Router Manual V.1.1
53
AT%SDL n
Re-Flash the new software
0
1
• Upgrade software by program area
only
• Upgrade the program area and boot
sector
AT%N=x
Set data port directory number / sub-
address
(eg. AT%N=12345678 + 12345)
x
• x=telephone number
main - address: max 20 digits
sub - address: max 5 digits
AT%Sn
Data port call screen function enable
0
*1
• accept incoming call if the calling
party number is in the call screen
table
• accept all incoming call
AT%Z1
Software reset
Reset all internal state of TA
AT$AAn
Set analog port A voice information
capability in answer mode
0
1
*2
• accept speech
• accept 3.1kHz audio
• accept both
AT$AN=x
Set analog port A directory number /
sub-address
Eg:AT$AN=12345678+12345
x
• X = telephone number
Main - address: max 20 digits
Sub - address: max 5 digits
AT$AOn
Set analog port A voice information
capability in originate mode
*0
1
• select speech
• select 3.1kHz audio
AT$APn
Dial pause set up for analog port A
*1
2
3
4
• 5sec
• 9sec
• 11sec
• 13sec
AT$ASn
Screen incoming call for analog port A
0
*1
• accept incoming call if the calling
party number is in the call screen
table
• accept all incoming call
AT$BAn
Set analog port B voice information
capability in answer mode
0
1
*2
• accept speech
• accept 3.1kHz audio
• accept both
AT$BN=x
Set analog port B directory number /
sub-address
(eg. AT$BN=12345678 + 12345)
x
• x = telephone number
main - address: max 20 digits
sub - address: max 5 digits
AT$BOn
Set analog port B voice information
capability in originate mode
*0
1
• select speech
• select 3.1kHz audio
AT$BPn
Dial pause set up for analog port B
*1
2
3
4
• 5sec
• 9sec
• 11sec
• 13sec
AT$BSn
Screen incoming call for analog port B
0
*1
• accept incoming call if the calling
party number is in the call screen
table.
• accept all incoming call
AT$CC
Display advice of accumulate charge
Display advice of accumulate charge
( data port, analog port A, analog port B)
AT$CD
Display all analog port setting
Display all of the setting for analog port
A and B
AT$CGn
Global call select setting
If the incoming call did not contain the
called party number ¡Athen TA had to
determine ring mechanism
0
1
*2
• ring TEL-A only
• ring TEL-B only
• ring both TEL-A and TEL-B